Dot1X Timeout Tx-Period - SMC Networks TIGERSWITCH SMC6752AL2 Management Manual

Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#

dot1x timeout tx-period

This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no
form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#
A
UTHENTICATION
C
OMMANDS
4-113