Enabling / Disabling Beeper - SentrySafe CHW30300 Owner's Manual

Enabling / Disabling Beeper

Press and hold the 1 and 9 on the keypad simultaneously for 3
1
seconds.
If the beeper is enabled, the green LED light will flash and the
2
beeper will sound. If the beeper is disabled, the green LED will
flash but have no sound.
6
Troubleshooting / Customer Service
The Problem: Why It Is Happening:
Red LED blinks three times Incorrect code has been entered/
programming error
Programming error
Red LED slowly blinks for An incorrect code has been entered
two minutes three times, safe is in lockout mode
Yellow LED blinks once Battery power is low
every thirty seconds
No LED indication when Power failure
pressing key pad buttons
Customer Service
Customer Service
www.sentrysafe.com
Phone Number: 1-800-828-1438
The Solution:
Verify the code and re-enter or
reprogram
Wait for two minutes, re-enter
personal or factory code
Replace with 9 volt alkaline
batteries (do not use rechargeable
or any other type of non-alkaline
battery)
Replace with 9 volt alkaline
batteries (do not use rechargeable
or any other type of non-alkaline
battery)
7