Samlexpower SEC-1235 Owner's Manual page 14

SECTION 5
g) Switch on the unit by pressing down on the edge of the switch marked
" – ". Neon light inside the switch will be lighted
h) 13.8 VDC will now be available at the DC output terminals (4, 3 in Fig 2.1 / 2.2)
i) Now switch on the DC load
5.3 SWITCHING OFF PROCEDURE
a) Switch off the DC load first
b) Switch off the power supply by pressing down on the edge of the switch
marked "o"
c) Unplug the AC power cord from the AC outlet
5.4 TROUBLESHOOTING
Refer to the Troubleshooting Guide at Section 7 in case of any abnormal operation.
SECTION 6
!
6.1
CAUTION!
Conducted and radiated noises in this unit are limited as per the applicable
National / International Standards as detailed under Compliance: EMI in
Section 8.
This unit generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, this does not guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the measures recommended
in the following paragraphs.
!
ATTENTION!
Bruits et rayonnement dans cette unité sont limitées que par la législation
nationale / normes internationales comme détaillé dans le cadre de
conformité : EMI dans la section 8.
Cet appareil génère, utilise et peut émettre une énergie de fréquence
radio et, s'il n'est pas installé et utilisé conformément aux instructions, peut
causer des interférences nuisibles aux communications radio. Cependant,
14 | SAMLEX AMERICA INC.
| Operation
| Limiting Electro-Magnetic
Interference (EMI)