Selecting The Base Interface Type; Interface Selection; Configuring The Interface - Datalogic QuickScan QM21X1 Quick Reference Manual

Selecting the Base Interface Type

Selecting the Base Interface Type
Upon completing the physical connection between the base
and its host, proceed directly to Interface Selection (below) for
information and programming for the interface type the base
is connected to (for example: RS-232, Keyboard Wedge, USB)
and scan the appropriate bar code to select your system's
correct interface type.

Interface Selection

The base will support the following host interfaces:
• RS-232
• RS-232 OPOS
• USB
• Keyboard Wedge
For defaults and additional information associated with each
interface, proceed to the corresponding chapter in the Quick-
Scan Q21XX PRG.

Configuring the Interface

Scan the programming bar code which selects the appropriate
interface type for the system the reader will be connected to.
Unlike some other programming features and
options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to
NOTE
scanning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while
in this state, pull the trigger and hold for 5
seconds. The scanner will change to a state
that allows programming with bar codes.
12 QuickScan™ QM21X1