Selecting The Base Interface Type; Interface Selection; Configuring The Interface - Datalogic QuickScan QBT2430 Quick Reference Manual

Selecting the Base Interface Type

Upon completing the physical connection between the base
and its host, proceed directly to Interface Selection below for
information and programming for the interface type the base
is connected to (for example: RS-232, Keyboard Wedge, USB,
etc.) and scan the appropriate bar code to select your sys-
tem's correct interface type.

Interface Selection

The base will support the following host interfaces:
• RS-232
• RS-232 OPOS
• USB
• Keyboard Wedge
For defaults and additional information associated with each
interface, proceed to the corresponding chapter in the Quick-
Scan Q2400 PRG.

Configuring the Interface

Scan the programming bar code which selects the appropriate
interface type for the system the reader will be connected to.
NOTE
Quick Reference Guide
Unlike some other programming features and
options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scan-
ning an interface selection bar code.
Some interfaces require the scanner to start in a
disabled state when powered up. If additional
configuration is desired in this state, pull the
trigger and hold for 5 seconds to change to a
state that allows programming with bar codes.
Selecting the Base Interface Type
21