Suzuki Ertiga Series Owner's Manual page 86

EXAMPLE
(1)
(2)
58MST0302
1) Without depressing the brake pedal,
push the engine switch (1).
2) Within about 10 seconds during which
the "PUSH" indicator light in the instru-
ment cluster is blinking, touch the
engine switch with the "LOCK" button
end of the remote controller (2) for
about 2 seconds.
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorized SUZUKI dealer for an
inspection of the system.
• The immobilizer/keyless push start sys-
tem warning light come on for about 5
seconds while the "PUSH" indicator light
is blinking. Refer to "Warning and Indica-
tor Lights" in the "BEFORE DRIVING"
section for details.
• You may customize the system to cause
the interior buzzer to sound once for the
"remote controller out of sensing range"
warning. To incorporate this customiza-
tion, please contact an authorized
SUZUKI dealer.
• If the battery of the remote controller is
about to become completely discharged,
the keyless push start system remote con-
troller battery consumption warning light in
the instrument cluster will come on for a
few seconds when you press the engine
switch to change the ignition mode to
"ON". Refer to "Warning and Indicator
Lights" in the "BEFORE DRIVING" section
for details. For details on replacing the bat-
tery, refer to the "Keyless Push Start Sys-
tem Remote Controller" in the "BEFORE
DRIVING" section.
OPERATING YOUR VEHICLE
"Remote Controller Outside" Warn-
ing
When the conditions described below are
met, the system gives a "remote controller
outside" warning by sounding the interior
and exterior buzzers and blinking the
immobilizer/keyless push start system
warning light.
• Any door is opened and then closed
while the remote controller is not inside
the vehicle and the engine is running or
the ignition mode has been changed to
"ACC" or "ON" by pressing the engine
switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to "ACC" or "ON" by pressing the engine
switch.
60MK1-82E
3-6