Siemens SIMATIC NET Operating Instructions Manual page 27

Setting the configuration
In the following table, it is assumed that configuration 0 is currently set.
1. To change between the available configurations, press the "SET" button briefly in the
Pressing the "SET" button
starting from configuration 0
Press once
Press twice
Press three times
Press four times
Note
Configurations and LED display
You will find the configurations available to you for startup time or the monitoring voltage and
the corresponding indications of the LEDs in the sections ""DM" LED (Page 28)" and "LEDs
"S1" and "S2" (Page 29)".
Saving the configuration
1. To store the set configuration permanently on the device, avoid pressing the "SET" button
Note
LED display
You will find the corresponding LED displays in the sections ""DM" LED (Page 28)" and
"LEDs "S1" and "S2" (Page 29)".
SCALANCE XC100-4OBR
Operating Instructions, 10/2013, C79000-G8976-C297-02
relevant configuration mode.
for approximately 10 s in configuration mode.
Once the 10 s have elapsed, you are in the relevant display mode.
Description of the device
Configuration
1
2
3
0
3.6 "SET" button
27