Initial Setup - Bunn G Series Installation & Operating Manual

INITIAL SET-UP
CAUTION
- Unplug the grinder throughout the initial set-up.
1. Open the top lid. Clear all foreign objects and shipping materials from the hopper compartment.
2. Remove the black safety plug (located in the entrance to the grind chamber), before installing the
hopper. Here are the steps:
1
6
7
8
Replace the outer hopper
collar, then the two screws.
3. The grinder can now be plugged-in and put into service, or if it needs calibrated, follow the
BURR ADJUSTMENT steps on the next page.
2
Remove left and
right screws from
the hopper collar.
7
Remove
4
Safety Plug
Pull collar off.
3
The hopper is now in ready.
Align hopper tab
5
with notch in cover
and slide in until the
hopper engages the
inner collar.
092518