DECAL INSTALLATION INSTRUCTIONS
If preferred, the numbered dial decal can be replaced with the symbols dial decal included with the grinder.
Here are the steps to exchange them:
Turn knob clockwise
1
till indicator points to zero.
Remove the knob.
4
Replace right screw on knob.
7
NOTE: If needed, follow the
Remove left screw on knob.
2
Pull the tab to remove the
5
adhesive strip on the back
of the symbols decal. Place
the decal directly over the
numbers decal.
Replace left screw on knob.
8
BURR ADJUSTMENT
10
Remove right screw on knob.
3
If the decal is placed in the
6
correct location (the screws
should both show through
the decal), then press to
adhere. Now, replace knob.
The decal is ready.
instructions on page 7.
092518