Electrical Requirements; Operating Controls - Bunn G Series Installation & Operating Manual

ELECTRICAL REQUIREMENTS

CAUTION
- The grinder must be disconnected from the power source until specified in Initial Set-Up.
Data Plate on the Grinder, and local/national electrical codes to determine circuit requirements.
100V & 120V
Models

OPERATING CONTROLS

Grind Selector
Allows the user to vary the grind for each coffee. Each setting will provide precisely the same grind every
time it is selected.
Off/On/Start Switch
STOP/OFF
- (upper position) Switching to this position stops the operation of the grinder.
ON
- (center, resting position) The switch will return to this position after a grind cycle has begun and
will remain in this position after grinding has ceased.
START
- (lower, momentary position) Pressing the switch initiates grinding only when a bag or other
container is in place behind the chute or if using the optional trifecta kit; the brew cup is in place.
Bag/Brew Cup Switch
Prevents the grinder from operating unless the back of a bag is in place behind the dispense chute or the
optional trifecta brew cup is not in place. Do not attempt to bypass this safety device.
Cleaning Lever
Allows the operator to clean out any coffee residue left from the previous grind.
Bag Clamp
Allows the operator to clamp the coffee bag in place and not have to hold it during the grind operation.
220-240V
CE Models
220-240V
CE Models
6
Refer to
NOTE:
This electrical service
consists of 2 current carrying
conductors (L1 and Neutral)
and a separate conductor for
chassis ground.
092518