Dyna-Glo DGPH402SS Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
5. Secure the bottom plate (R) and the lower
supports (K) with three M5 x 12 mm screws
(EE) as illustrated.
Secure the control box assembly (I), the lower
supports (K) and the upper supports (G) with
six M5 x 12 mm screws (EE) as illustrated.
Tighten all screws with the Phillips
screwdriver (OO).
Hardware Used
M5 x 12 mm Screw
EE
Phillips
OO
screwdriver
6. Note: Make sure to attach the block belt on
the same side as the wheel assembly (Q).
Attach the block belt (J) to the lower supports
(K) with two M5 x 12 mm screws (EE). Tighten
with the Phillips screwdriver (OO).
Hardware Used
M5 x 12 mm Screw
EE
Phillips
OO
screwdriver
5
G
x 9
K
6
x 2
9
I
R
J
Q
EE
EE
K
EE