Advertisement
4.Operation Instruction
1.Open the packing container and take out the unit. Check whether there are an
instruction manual, a remote controller and four ice packs.
2.Do not tilt the unit during operation. Check whether the socket power meets the
parameters on the nameplate of the unit.
3.Filling water: Draw out the water tank(See Fig.1).
Note: Before filling the water tank with water, please take out the pearl wool.
When using a new unit or a unit that hasn't been used for a long time, please use
clean tap water. Before filling water, please unplug the power plug to prevent potential
damage to the unit and electrical shock hazard.
Just fill the water to the max. water line, otherwise the water will overflow.
4.Note: For placing water tank:
After removing the water tank, the normal status of pump shall be as shown in fig. 2:
the pump shall be propped up by the supporting rod; when placing the water tank, the
supporting rod shall incline inwards naturally and then the pump will dip into the water
tank.
After removing the water tank, if the pump falls down due to vibration or inclination (as
shown in fig. 3), you cannot place the water tank in this case. Please lift the pump
manually and then place the water tank when the pump is in the position as shown in
fig. 2.
5.Remote Controller Operation: the functions of some buttons on the remote controller
are the same as those on the control panel. Point the infrared transmitting tube at the
main body when operating. There should be no obstruction between the remote
controller and the main body.
6.Storage: if the unit is to be stored for a long time, make sure the water tank is empty.
Blow air in normal temperature for a while. Make sure the evaporator in the unit is
completely dry before the unit is put into plastic bag. Store the unit in the box for future
use.
7.Cleaning: When the unit has been operated for a period of time (approx, 2 weeks, depending
on the water cleaness), much dust and sundries will be accumulated on the water tank, filter
of water tank, evaporator and filter of evaporator, which will affect the air volume and
cooling effect. For the optimal operation status of the unit and prolonging the lifespan of unit,
please contact an authourised SHARP after-sales service personnel to clean the unit periodically
Note: please pull out the power plug before cleaning.
8.Please put the evaporator at the appointed position in unit during operation, otherwise,
it will affect the unit's operation and service life.(or it may lead the motor to burn out)
9.Please check whether there's water in water tank when moving. If there's water in water
tank, please drain the water.
.
-3-
(Note: Never move the unit when there's water in water tank for fear of water
overflowing.)
10.Please make sure the unit is turned off before removing the evaporator, otherwise,
it may lead to water overflowing.
Fig. 1
supporting rod
of pump
Fig 2
5.Safety Notice
1.Please use the normal power supply voltage 220-240V~ 50Hz and the independent 2.5A standard
socket complied with national standard to guarantee the safety(See Fig.4).
2.After the unit is filled with water, do not tilt or crash it when placing or moving the unit. If moving the
unit is necessary, please push it slowly to avoid overflowing. Tilting the unit during operation is
prohibited(See Fig.5).
220-240V~ 50Hz
Fig.4
Max. water level
Min. water level
pump falls down
Fig 3
Fig.5
-4-
Advertisement
