Photron FASTCAM Multi Hardware Manual page 7

■ Always unplug the system when cleaning it or when it is unused for a long period of time.
Leaving or storing the system connected to the power source might cause fire from insulation
deterioration or electrical discharge.
■Please consult us in advance when you perform an event by which laser light or direct rays fall
on the image sensor surface.
■ Do not set the system in a location where the temperature gets unusually hot.
The trunk and inside of a car can get especially hot in summer.
Doing so can cause the outer case and internal components to deteriorate or cause a fire.
■ Do not place the system in a location prone to oily smoke or steam, or in a location with a lot of
humidity or dust.
Oil, moisture, and dust conduct electricity, which can cause a fire or electric shock.
■ Do not obstruct the air intake and exhaust port, when the system is installed.
■ Ambient temperature 0-45° C, humidity 80% RH or lower, maximum altitude 2,000m or lower.
In addition, if exceeding these limits, use in a condensation-free environment.
Use in a condition out of the above limits can cause malfunction.
■ Do not store the equipment in a location where the temperature goes below -20°C or higher
than 60°C. Also, prevent condensation from forming during shipment.
■ When shipping, remove the connecting cable and use the original packaging or a dedicated
carrying case.
Do not ship the equipment in an environment where the temperature goes below .
-20°C or higher than 60°C. Also, prevent condensation from forming during shipment.
■The rubber foot used in this product might be hydrolyzed if it is stored or used in a high
humidity environment for a long time.
Moreover, it might be hot melted if it is stored or used in a high temperature environment
for a long time.
Caution