Machine Inspection - RIDGID 1215 Manual

Figure 2 – Mounting Machine to Stand
Mounting Machine To Bench
1. If a stand is not used, the machine should be
mounted to a stable bench. To mount the unit on a
bench, use three (3) bolts in holes provided in the ma-
chine base.
Failure to mount the threading machine
WARNING
to a stable stand or bench may result in tipping and
serious injury.

Machine Inspection

WARNING
To prevent serious injury, inspect your Threading
Machine. The following inspection procedures
should be performed on a daily basis:
1. Make sure Threading Machine is unplugged and the
ON/OFF switch is set to the OFF position (Figure 3) .
1215 Threading Machine
No. 732
Cutter
Chuck
Handwheel
Rear Centering
Device
Foot
Switch
Carrying
Handle
On/Off Switch
Figure 3 – No. 1215 Threading Machine
2. Clean the speed chuck jaws with a wire brush.
3. Inspect the jaw inserts for excessive wear. Refer to
the Maintenance Instructions if they need to be re-
placed.
NOTE! For plastic and coated work pieces, special jaw
inserts (No. 58302) should be used to prevent
damaging the workpiece.
4. Make sure the foot switch is present and attached to
the Threading Machine.
Do not operate the Threading Machine
WARNING
with out a foot switch.
5. Inspect the power cord and plug for damage. If the
plug has been modified, is missing the grounding
pin, or if the cord is damaged, do not use the Thread -
ing Machine until the cord has been replaced.
6. Inspect the Threading Machine for any broken, mis -
sing, misaligned or binding parts as well as any other
conditions which may affect the safe and normal op-
eration of the machine. If any of these conditions
are present, do not use the Threading Machine until
any problem has been repaired.
7. Lubricate the Threading Machine if necessary ac-
cording to the Maintenance Instructions.
8. Use tools and accessories that are designed for your
Threading Machine and meet the needs of your ap-
plication. The correct tools and accessories allow
you to do the job successfully and safely. Accessories
designed for use with other equipment may be haz-
ardous when used with this Threading Machine.
9. Clean any oil, grease or dirt from all handles and
controls. This reduces the risk of injury due to a tool or
control slipping from your grip.
Die Head
No. 323
Reamer
Carrying
Handle
Carriage
Handwheel
5