Chapter 2 Settings
LLDP-MED Port
Configure LLDP-MED for each port.
Status
Notification
Capabilities TLV
Network Policy TLV
Extend Power TLV
Software Revision TLV
If enabled, LLDP-MED will be transmitted.
Note: To use this functionality, configure the status to [Tx Only] or [Tx and Rx] on
the [LLDP Port] page.
If enabled, the SNMP trap will be sent to the SNMP server when the LLDP-MED
information in the neighbor table is updated.
Note: To use notification, configure SNMP manager and SNMP trap settings.
If enabled, the capabilities will be included in LLDP packets.
If enabled, the network policy will be included in LLDP packets.
If enabled, the extend power will be included in LLDP packets.
Note: This functionality is compatible with PoE switches only.
If enabled, the firmware version will be included in LLDP packets.
28