Snmpv3 User - Buffalo BS-GS20 Series User Manual

Chapter 2 Settings

SNMPv3 User

Configure information of users who are authenticated with SNMPv3. SNMPv3 will authenticate users using
username and the authentication can be encrypted. This switch is compatible with the following authentication and
encryption method.
Authentication method: HMAC-MD5-96/HMAC-SHA-96
Encryption method: CBC-DES/CFB-AES-128
Engine ID
Username
Access Control
Authentication Method
Authentication Key
Encryption
Encryption Key
This is the switch's unique ID to identify SNMP engine. This ID will be notified to
other side when SNMPv3 communication is done.
Enter the username to authenticate. The username should be up to 32
alphanumeric characters, hyphens (-), and underscores (_).
Limit the access depending on the user.
Read Only
Prohibit writing.
Read/Write
Permit any access.
Configure the authentication method.
Enter the key phrase compatible with the authentication method.
Configure the encryption method.
Enter the key phrase compatible with the encryption method.
25