Vlan Ports - Buffalo BS-GS20 Series User Manual

Chapter 2 Settings
Static Default Gateway
Dynamic Global Address
Dynamic Default Gateway
Note: In L3 mode, you can configure the default gateway from the [Routing] - [Static Routing] page.

VLAN Ports

Configure PVID (Port VLAN ID).
PVID
Acceptable Frame Type
Ingress Filter
Protected Port
Enter the default gateway to configure an IPv6 default gateway manually. The
default gateway prefix should be the same as the static global address.
Displays the dynamic global address obtained from DHCPv6 or router
advertisement.
The address with the trailing "SF" means that the address was obtained from
DHCPv6. The address with the trailing "SL" means that the address was obtained
from router advertisement.
Displays the default gateway obtained from router advertisement.
Specify the port VLAN ID. The received untagged frames will be recognized as the
specified VLAN ID. (1-4094)
Admit All
Receive both untagged and tagged frames.
Tag Only
Receive tagged frames only and drop untagged frames.
Enable
Drop frames if the received frame's VLAN ID is not a member of incoming port's
VLAN.
Disable
All tagged and untagged frames will be received.
"Protected Port" enabled ports cannot communicate with each other.
20