Install And Turn On R3; Install/Power On; Windshield - Uniden R3 User Manual

OLED EXAMPLES
Time Display (Scan Display
Off)
11:45
12.8
P
M
Volt
Quiet Ride
K
55
24.120 GHz
mph
Dark Mode

INSTALL AND TURN ON R3

You can mount the R3 on the windshield (1- and 2- cup suction brackets included) or
on the dashboard (hook and loop tape included).

INSTALL/POWER ON

Windshield

When you mount the R3 on the windshield, mount it in the middle of the windshield
between the driver and passenger. Be sure there are no obstructions and that there
is a clear view through the windshield.
1. Attach the rubber suction cups to the bracket and push the cups firmly onto the
windshield.
2. Slide the unit onto the bracket until it clicks into place.
3. Plug the power cord RJ11 connector into the R3 and plug the cigarette lighter
adapter into the vehicle's cigarette lighter.
4. When the vehicle turns on, the R3 automatically turns on and runs through a
self test cycle.
Release the R3 from the bracket by pressing the Eject key on top of the detector.
MEANING
Information displayed:
• Voltage
• Time and AM/PM
Hwy
• Highway/City/Advanced
Information displayed:
• Current speed in mph/km/h
• Band type Type (X, K)
Q-Ride
• Frequency number
• Status Area (Q-Ride displays)
Set mode to Dark if the unit's OLED is not
anticipated to change a lot to prevent image
burn-in (Auto Dim setting).
In Dark mode, the OLED is dark with a single
white dot in the lower corner that moves from
bottom left to center to bottom right. The
movement of the dot confirms that the unit is
still powered up.
- 11 -