Preparation; Filter Installation; Operation; Start/Stop - Sharp KC-G60Y Operation Manual

PREPARATION

FILTER INSTALLATION

1
Remove the Back Panel.
2
Remove the plastic bag
from the each filter.
HEPA Filter

OPERATION

START/STOP

START

ANTI DUST MODE

The unit releases Plasmacluster ions with strong airflow
and collects dusts while decreasing static electricity for
10 minutes. After that, the DUST sensor sensitivity is
automatically set to "HIGH" and quickly detects impurities
and clean the air powerfully for 50 minutes.
NOTE
• When the operation finishes after 60 minutes, the unit will
return to the prior operation mode. It is able to change the
other mode during this mode.
• The Plasmacluster Ion can not be turned "OFF". (Ref.E-9)
Back Panel
Deodorizing Filter
STOP
Always be sure to remove the
power plug from the wall outlet.
3
Install the filters in the correct order as
shown.
4
Install the Back Panel.
3
NOTE
• When replacing the filter, making a memo of the start of
use date is recommended.
INTELLIGENT MODE
The fan speed is automatically controlled depending on the 7
detection. (Ref.E-1)
AUTO MODE
The fan speed is automatically controlled depending on the
5 detection. (PM2.5 / Usual dust / Temperature /Humidity /
Light)
NOTE
• Front Display, Cleanliness Monitor and Air Outlet LED
automatically switch ON and OFF based on room
brightness. (When light control is set to "Auto". Ref.E-10)
E- 7
HEPA Filter
Tag
Deodorizing Filter
Click
2
3
(KC-G60 / KC-G50)
(KC-G40)
1