Table of Contents
Advertisement
7.4
Tilt alarm
The BENOMIC STAR is fitted with a tilt indicator alarm with an acoustic warning signal. The
tilt indicator provides an acoustic signal when the machine is tilting over in excess of 2.
When this occurs all work being carried out must stop immediately, the scissor
mechanism should be lowered as far as possible, and the operator should step off the
BENOMIC STAR then take it back while walking beside it. Thereafter the pipe rail system
should be adjusted before any activities can be restarted. First test the prepared section of
rails with the scissor mechanism in the lowest position and at low speed. If there are no
problems with this, test again with the scissor mechanism in the highest position at minimum
speed. Normal activities can be restarted if no problems arise.
Always try to find a permanent solution to prevent the machine tilting on the rails!
16
39
Translated user manual
BENOMIC STAR
/
Advertisement
Table of Contents
