Graco ToughTek M680a Operation - Repair - Parts page 4

Models
Applicators
Flex Applicator
The flex applicator is for use in low pressure spraying
of materials that packout easily and will be
finish-troweled.
Includes 23 in. (58 cm) flexible hose with a 1 in. camlock
fluid inlet, angled spray head, spray air volume control,
spray air shut off valve, and motor pilot signal control
valve; an adjustable-position center air injection tube, a
rubber tip retainer, and three tip sizes.
Pole Applicator
The pole applicator is for use in low-pressure spraying
in long-reach, open areas, using materials that packout
easily and will be finish-troweled. The pole applicator is
similar to the flex applicator but includes a pipe instead
of a hose.
Includes a 30 in. (76 cm) aluminum pipe with a 1 in.
camlock fluid inlet, angled spray head, spray air volume
control, spray air shut-off valve, and motor pilot signal
control valve; an adjustable-position center air injection
tube, a rubber tip retainer, and three tip sizes.
HTX 680 Applicator
The HTX 680 applicator is for use in medium-pressure
spraying of materials that do not packout easily.
The HTX 680 uses venturi-type air injection fluid nozzles
and an aluminum screw on tip retainer. The applicator
includes a 1 in. camlock fluid inlet, angled aluminum
spray head, spray air volume control, spray air shut off
valve, and motor pilot signal control valve. Also includes
four nozzle sizes, a Fine Finish adapter, and four Fine
Finish tips.
4
F . 5: Flex Applicator
IG
F . 6: Pole Applicator
IG
F . 7: HTX 680 Applicator
IG
3A5275B