Sirius Satellite Radio STAREMATE REPLAY ST2 User And Installation Manual page 11

PROTECTIVE MATERIAL
(RED SIDE)
ADHESIVE
STRIP
ANTENNA
CABLE
Temporarily position the antenna and rubber antenna
cable cover/tail in the selected mounting area and
route the cable from the antenna to the vehicle's
interior by tucking it underneath the rubber molding
around rear window, as shown.
ST2 Starmate Replay User and Installation Guide
ANTENNA
(UNDERSIDE)
RUBBER ANTENNA
CABLE COVER/TAIL
Route the cable from the lowest point of the rear
window into the trunk. Take advantage of any
existing cable channels or wiring conduits. For
SUVs, mini-vans & 5-door vehicles, bring the cable
into the vehicle under the rubber molding for the
tailgate, and continue under the interior trim.
From the trunk, or rear of the vehicle, route the cable
around the passenger compartment and to the front
of the vehicle, to the receiver. Take care not pull the
cable across sharp edges that could damage it, and
keep it away from areas where it might entangle
feet. Coil any excess antenna cable in a location
where it can be hidden.
Once the antenna cable is routed through the
vehicle, and you are satisfied with the cable routing,
peel the yellow protective material from the
adhesive strip and adhere the adhesive strip to the
rubber antenna cover/tail. Next peel the red
protective material from the adhesive strip and
press the rubber antenna cable cover/tail firmly into
place on the vehicle.
11