Sending An Emergency Alarm And Call With Hot Mic - Motorola APX 8000XE 1 User Manual

English
4 Release the PTT button to end the transmission and
wait for a response from the dispatcher.
5 To exit Emergency Call, press and hold the
preprogrammed Emergency button for about a
second.
Turning off the radio also cancels the emergency
state.
Sending An Emergency Alarm and Call
with Hot Mic
This feature allows you to send an Emergency Alarm and
Call with hot mic to a group of radios.
Your radio must be programmed for this type of operation.
Follow the procedure to send Emergency Alarms and Call
with hot mic on your radio.
1 Press the preprogrammed Emergency button.
If successful, the display shows EMERGNCY on the
current zone and channel. A tone sounds and the
LED blinks red momentarily.
64
The radio exits Emergency Alarm and enters the
Emergency Call state when one of the following
scenarios occur:
• You receive the dispatcher acknowledgment. The
display shows ACK RCVD.
• You receive no acknowledgment. The display
shows NO ACK.
If unsuccessful, a tone sounds to indicate the
selected channel does not support emergency and
rejects to launch emergency mode.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
3 The microphone remains active for the hot mic time
specified in your radio's codeplug programming.
4 To exit Emergency Call, press and hold the
preprogrammed Emergency button.
Turning off the radio also cancels the emergency
state.