Ceiling Mount A/V And Guard Installation Reference; Strobe And Idnac Slc Controller Compatibility Reference; Specifications - Simplex TrueAlert 4906-9228 Instructions

Ceiling Mount A/V and Guard Installation Reference

Optional 4905-9915 (white) or 4905-9916 (red)
Adapter, recommended for surface mounted box
Ceiling reference,
surface mounted box
Magnetic test area
TrueAlert Strobe and IDNAC SLC Controller Compatibility Reference
Compatible Controller
4100ES with EPS+ or EPS Power Supply
4009 IDNAC Repeater

Specifications

(see page 2 for dimensions)
General Specifications
Environmental
Connections
Reference
Electrical Specifications
Typical Operating Voltage Range
Flash Rate and Synchronized SLC Loading
Horn Output Selection
23 VRMS Current Ratings, for connection to
IDNAC Addressable SLCs, horn steady on
Horn Output Characteristics
Sound Type (see Note)
Horn Output Ratings
Reverberant Chamber,
@ 10 ft (3 m)
Note: Coded horn values are typical of the output measured with a Temporal or March Time pattern and with a sound level meter
reading on a "fast" setting. Under the same test conditions, coded horn output "peak" sound level readings are typically 4 dBA
higher.
4" (102 mm)
square box,
1-1/2" (38 mm)
minimum depth
Ceiling reference,
flush mounted box
Wiring terminals and address setting
are located behind the housing
Data Sheet
Reference
S4100-0100
S4009-0004
32° to 122° F (0° to 50° C); 10% to 93%, non-condensing at 100° F (38° C)
Terminal blocks for 18 AWG to 12 AWG (0.82 mm
terminal for in/out wiring
Installation Instructions 579-808
23 VRMS to 31 VRMS, Special Application (see page 4 for 17 VRMS rating)
1 Hz; with up to 46 synchronized strobes maximum per NAC; maximum 30 Ω
resistance between appliances
Candela Setting
15 cd
High
75 mA
2400 to 3700 Hz sweep, modulated at 120 Hz rate
Setting
High
84.6 dBA
UL 464 Test
Anechoic Chamber 90 dBA
Optional 4905-9927
Red Wire Guard
End View
Strobe intensity viewing slot
Intensity selection plug,
accessible only from rear of
lens housing; factory setting is
FACP, controlled by panel
LED indicator
Strobe housing straight-on view
Controller
Output
IDNAC SLC
30 cd
Low High Low
70 m A 110 mA 105 mA
Steady
Low
79.1 dBA
84 dBA
3
Optional 4905-9928
Adapter Plate, required
for surface mounted
electrical box
Four mounting clamps
included, two each side
IDNAC SLC Appliance Voltage
Output Voltage Design Reference
23 VRMS
29 VRMS
(regulated)
(with 6 VRMS drop)
2 2
to 3.31 mm ); two wires per
75 cd 110 cd
High Low High
198 mA 193 mA 250 mA
Coded
High Low
80.6 dBA 75.5 dBA
86 dBA 80 dBA
S4906-0005-3 5/2013
Low
245 mA