Samsung AMxxxNN1DEH Series Installation Manual page 22

Installation Procedure
WARNING
• In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses and
options
Entering the
mode for setting
the options
High Temp button
Low Temp button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
22
English
DVM TK Wind-Free 1way IM EN_DB68-07553A-00.indb 22
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
2 Set the option values.
CAUTION
• The total number of available options are 24: SEG1 to
SEG24.
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the following
order: SEG2 and SEG3
Setting the
SEG8
option values
and SEG15
SEG21 and SEG22
SEG1
Mode button
0
High Fan button
SEG7
Low Fan button
1
SEG13
2
SEG19
3
On (SEG1 to SEG12)
(High Temp) and
SEG4 and SEG5
→
SEG9 and SEG10 SEG11 and SEG12
→ →
SEG16 and SEG17 SEG18 and SEG20
→ →
SEG23 and SEG24
→
SEG2 SEG3 SEG4
X X X
SEG8 SEG9 SEG10
X X X
SEG14 SEG15 SEG16
X X X
SEG20 SEG21 SEG22
X X X
Off (SEG13 to SEG24)
SEG6 and
→
SEG14
→
→
SEG5 SEG6
X X
SEG11 SEG12
X X
SEG17 SEG18
X X
SEG23 SEG24
X X
2017-12-01 오후 2:19:06