Aqua Lung EA-4500 LW Technical Manual page 25

PART #
103549
108305
054300 / 054232
108308
103530 / 102810
108318
AP5752
TEST
Leak Test
MP
MP Creep
Opening Effort
Flow Effort
Purge Flow
TABLE 6: RECOMMENDED CLEANERS AND LUBRICANTS
LUBRICANT/CLEANER
Christo-Lube MCG 111
Oakite #31
White distilled vinegar
Liquid dish washing detergent
(diluted with warm water)
TABLE 4: TORQUE SPECIFICATIONS
DESCRIPTION / KEY ITEM #
HP Module Body (13)
Swivel Port Plug (41)
Safety Plug Assy (35)
Fill Port (32)
Dial Indicator Gauge (14)
Bonnet (23)
Diaphragm Clamp (3)
TABLE 5: TEST BENCH SPECIFICATIONS
CONDITION
Inlet 3000 PSI (207 BAR)
Inlet 3000 PSI (207 BAR)
Inlet 3000 PSI (207 BAR)
Inlet 3000 PSI (207 BAR)
MP 145 ±5 PSI (10± 0.34 BAR)
MP 145 ±5 PSI (10± 0.34 BAR)
APPLICATION
All o-rings
CAUTION: Silicone rubber requires no lubrication or preservative treatment. DO
NOT apply grease or spray to silicone rubber parts. Doing so may cause a chemical
breakdown and premature deterioration of the material.
Acid bath for reusable stainless steel and
brass parts.
CAUTION: Do not use muriatic acid for the cleaning of any parts. Even if strongly
diluted, muriatic acid can harm chrome plating and may leave a residue that is
harmful to o-ring seals and other parts.
Acid bath for reusable stainless steel
and brass parts.
Degreaser for brass and stainless steel
parts; general cleaning solution for plastic
and rubber
TORQUE
25 ft lb (33.9 Nm)
60 in lb (6.8 Nm)
90 in lb (10.2 Nm)
90 in lb (10.2 Nm)
45 in lb (5 Nm)
90 in lb (10.2 Nm)
15 ft lb (20 Nm)
SPECIFICATION
No leaks allowed
145 ±5 PSI (10 ± 0.34 BAR)
5 psi (0.34 BAR) max between 5 to 15
seconds after cycling regulator (purge)
+2.5 to +3.5 inch H 0 (6.2 -8.7 mbar)
2
+5 inches H 0 (12.5 mbar) (maximum) at
2
8 SCFM (227 LPM)
5 SCFM (142 LPM) flow rate (minimum)
SOURCE
Aqua Lung, (PN 820466) or
Lubrication Technologies
310 Morton Street
Jackson, OH 45640
(800) 477-8704
Oakite Products, Inc.
50 Valley Road
Berkeley Heights, NJ 07922
"Household" grade
"Household" grade
25