Page 1
Balmoral IMPORTANT: KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE 请妥善保管本说明书以供日后参考...
Page 2
Contents Fitting the handle First check all your parts have been Attach the two S-shaped metal bars (C) supplied. Your Balmoral pram includes: with the flat side against the body onto the threaded bolts. Then attach the Body & Chassis sleeved nut ‘A’...
The hood and apron CAUTION: The child should be clear of moving parts while making adjustments. Lift hood into position and push down on the levers on both sides of the hood to secure in place. Fit the apron around the contour of the pram body and fasten the press studs on either side of the pram.
Page 4
6.4. Insert mattress on top of back support. Note: Ensure the head rest part of the mattress is nearest the hood. For advice on cleaning see the wash care label. WARNING: Only use the mattress provided by Silver Cross.
Page 5
Attaching the tray To fit the tray push the brackets through the underside of the tray and twist so the white plastic T bar lies on top of the tray. Each bracket should lie parallel to the cross wire as shown in 6.1a. Pull the black hooks on each end of the bracket over the frame of the pram and release the clips so that the tray is...
If however you should have any problems with your Balmoral Pram, please contact your Silver Cross retailer who will take appropriate action. This pram is intended to be used from birth up to 6 months.
Page 7
Accessories which are not approved by Silver Cross shall not Spares be used. A full range of spares for the entire Classic Collection product range by Silver Cross is Only replacement parts supplied/ available from www.heritage-prams.co.uk recommended by Silver Cross should be used.
Need help?
Do you have a question about the Balmora and is the answer not in the manual?
Questions and answers