Final Installation Checklist - Maytag MLG19PD Installation Instructions Manual

12. Final installation checklist

I I
Instructions and Installation Kit have been removed from inside.
I I
Shipping straps have been removed.
I I
Appliance has been properly levelled. All legs should be firmly on the floor and lock nuts MUST be
tightened.
I I
Water is turned on and checked for leaks at tap and water valve connections.
I I
Appliance is connected to electricity supply and is properly earthed.
I I
Drain hose is properly located into drain facility and is not kinked.
I I
All exhaust and gas connections to dryer are correctly made.
I I
Turn on gas supply (where applicable).
I I
Turn on water supplies.
I I
Switch on electricity supply.
I I
Following Operating Instructions, check the operation of the dryer first, then the washer.
Dryer – On gas dryers the burner may not ignite initially due to air in the gas pipework. Allowing the
dryer to operate on a heat setting will purge the pipework. If the gas does not ignite within 5 minutes,
turn the dryer off and wait for 5 more minutes. Make sure gas supply has been turned on. In order to
confirm gas ignition and correct operation of the burner (mostly blue flame) the professional installation
engineer may remove the front access panel to view the burner. WARNING: Do not touch any electrical
parts and replace panel immediately after this check. To confirm gas ignition at any other time, the
exhaust duct should be checked for heat.
Washer – Ensure washer fills properly on all temperature selections. Test for proper operation by
running the washer through a complete cycle.
Page 8