Installation With Fixed Pipework - Mira Coda Plus Installation & User Manual

Installation with Fixed Pipework

This section should be followed in
installations where it has not been possible
to achieve the 5 mm horizontal pipe
movement required to allow automatic
levelling of the bar valve.
1. Fit the locking washers over the offset
connectors.
2. Loosely fit the screws to hold the
offset connectors in place.
3. offer the bar valve up to the offset
connectors, and if necessary using
the finger grips, rotate the connectors
anti-clockwise to adjust the centres
so that they are in line with the bar
valve inlets and are level.
4. Firmly tighten the screws to lock the
offset connectors in position.
5. Caution! It is essential at this
point that the supply pipework is
thoroughly flushed through before
connection to the bar valve.
15
locking Washer