Removal of Electrical Box
4. Removal of Electrical Box
Procedure
Step
1. Disconnect the each
harness.
1
Remove the screw and
remove the drip proof
plate.
2
Remove the screw of
the earth / ground wire
and cut the clamp.
3
Pull out the indoor heat
exchanger thermistor.
4
Disconnect the
connector for the fan
motor [S1].
8
Warning
Be sure to wait for 10 minutes or more after turning off all power
supplies before disassembling work.
Procedure
Indoor heat
exchanger
thermistor
Earth /
ground wire
[S1]
Preparation
Remove the front grille
according to "Removal of
Front Grille".
(R5345)
Drip proof plate
(R5346)
Be careful not to lose the clip
for the thermistor.
Clip
(R18587)
(R5348)
Si04-955
Points
(R11234)
Removal Procedure