Setting The Saw Chain - Echo CS-310 Operator's Manual

CS-310
4. Use a wood or plastic scraping
tool to clean deposits from
cylinder exhaust port.
5. Install muffler. Tighten muffler
mounting bolts (or nuts) to 7 - 9
N•m (60- 80 in•lbf).
6. Install cylinder cover and attach
spark plug lead.
7. Start engine, and allow unit to
warm up at idle for several
minutes.
8. Stop engine, and re-tighten mounting bolts (or nuts) to 7 - 9 N•m (60-80
in•lbf).
9. Install guide bar and chain. Adjust chain tension.
10. Start engine and check for exhaust leaks between muffler and cylinder
head. Stop engine if leak is found and correct problem before operating
chain saw.

Setting The Saw Chain

Drive link
Tie strap
Right hand cutter
Important points for proper maintenance of saw chain:
• Keep the cutters sharp at all times.
• Keep the left and the right cutters properly aligned.
• Note that blunt or irregular cutters will result in poor
cutting performance, increased vibration of chains and
premature breakage of the saw chain.
X7503275401
© 02/2019 ECHO Inc.
Preset tie strap
Left hand cutter
Guard link
MAINTENANCE
Top plate
Side plate
Depth
gauge
49