Carburetor Adjustment - Echo CS-310 Operator's Manual

Hide thumbs Also See for CS-310:
Table of Contents

Advertisement

CS-310
* Replacement is recommended based on the finding of damage or wear
during inspection.

Carburetor Adjustment

Every unit is run at the factory and the
carburetor is set in compliance with
Emission Regulations. In addition, the
carburetor is equipped with "H" (High
Speed) and "L" (Low Speed) needle
adjustment limiters that prevent
settings outside acceptable limits.
Engine Break-In
New engines must be operated a minimum duration of two tanks of fuel
break-in before carburetor adjustments can be made. During the break-in
period your engine performance will increase and exhaust emissions will
stabilize. Idle speed can be adjusted as required.
High Altitude Operation
This engine has been factory adjusted to maintain satisfactory starting and
durability performance up to 1,100 feet above sea level (ASL) (96.0 kPa). To
maintain proper engine operation above 1,100 feet ASL the carburetor may
need to be adjusted by an authorized service dealer.
If the engine is adjusted for operation above 1,100 feet ASL, the
carburetor must be re-adjusted when operating the engine below
1,100 feet ASL, otherwise severe engine damage may result.
1.
Before adjusting carburetor clean or replace air filter and muffler "Spark
Arrestor Screen".
2.
Make sure the bar and chain are properly adjusted.
3.
Start engine and run several minutes to bring to operating temperature.
Flash choke twice during warm-up to clear any air from the fuel system.
4.
Stop engine. Turn "H" speed needle counterclockwise (CCW) to stop.
Turn "L" speed needle midway between full clockwise (CW) stop and
CCW stop.
5.
Idle Speed Adjustment:
• Start engine, turn "Idle" speed adjustment screw "T" CW until the saw
chain begins to move, then turn screw out CCW until the saw chain
stops moving. Turn screw out, CCW, an additional 1/4 turn.
X7503275401
© 02/2019 ECHO Inc.
MAINTENANCE
T
H
L
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents