Application Rules - D-Link DIR-604 User Manual

Section 3 - Configuration
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and
others. These applications have difficulties working through NAT (Network Address Translation). Special Applications
makes some of these applications work with the DIR-604. If you need to run applications that require multiple connections,
specify the port normally associated with an application in the Trigger port field, select the protocol type as TCP, UDP,
or Any, and then enter the firewall (public) ports associated with the trigger port to open them for inbound traffic.
The DIR-604 provides some predefined applications in the table on the bottom of the Web page. Select the application
you want to use and enable it. When you are finished on this page, go to the Schedule page (Maintenance > Schedule)
and create a schedule for when the application rule will be enabled.
Name:
Enter a name for the rule. You may select a
pre-defined application from the drop-down
menu and click <<.
Trigger: This is the port used to trigger the application. It
can be either a single port or a range of ports.
Traffic Type: Select the protocol of the trigger port (TCP,
UDP, or Any).
Firewall: This is the port number on the Internet side that
will be used to access the application. You may
define a single port or a range of ports. You
can use a comma to add multiple ports or port
ranges.
Traffic Type: Select the protocol of the firewall port (TCP,
UDP, or Any).
D-Link DIR-604 User Manual

Application Rules

55