Nokia 9500 User Manual page 87

file:///C:/USERS/MODEServer/tkoikkal/864507/RA-2_Erin/en/issue_1/ra-2_erin_en-us_1.xml file:///C:/USERS/MODEServer/tkoikkal/864507/RA-2_Erin/en/issue_1/ra-2_erin_en-us_1.xml
specify the network name here, you are asked to
select a network when you establish a wireless
LAN connection.
• Security mode — You must select the same
security mode that is used in the wireless LAN
access point. If you select
privacy) or WPA
must configure additional settings, too.
4. After defining the settings, press
define advanced settings, if necessary. Otherwise,
press Finish or
Configuring advanced Internet access
point settings
Press Advanced when you have finished setting up the
basic Internet access point settings.
The pages and options available depend on the settings
you have chosen. Ask your system administrator for the
correct values.
IP configuration page
Note that the two protocols (IPv4 and IPv6) require
slightly different settings.
• Auto retrieve IP — If you select Yes, the IP address
is obtained automatically from the server. This
setting is sometimes also called dynamic IP address.
If you select No, you must specify the IP address,
subnet mask, and default gateway in the fields
below.
• Auto retrieve DNS — If you select
protocol, or DHCP
and secondary DNS (domain name server) addresses
are obtained automatically from the server. DNS is
WEP (wired equivalent
(Wi-Fi protected access), you
Proxies page
Advanced to
You may want to use a proxy to quicken access to the
Internet. Note also that some Internet service providers
Done to exit the setup wizard.
require the use of Web proxies. Contact your Internet
service provider to determine proxy details.
If you have made an Internet connection to your
company's intranet, and are unable to retrieve Web
pages from the general Internet, you may need to
setup a proxy server to retrieve Web pages outside
your company's intranet.
Define the following:
•
•
•
•
Yes for the IPv4
for the IPv6 protocol, the primary
•
Page 87 Page 87 Jul 2, 2004 11:32:12 AM Jul 2, 2004 11:32:12 AM
an Internet service that translates domain names
such as www.nokia.com into IPv4 addresses such as
192.100.124.195, or IPv6 addresses like 3ffe:2650:
a640:1c2:341:c39:14. If you select No for the IPv4
protocol, or Manual for the IPv6 protocol, you must
specify the IP addresses for the primary and
secondary DNS servers.
Proxy protocol — Select the protocol type of the
proxy. You can set different proxy settings for each
protocol.
Use proxy server — Set this option to Yes
the proxy server.
Proxy server — Enter the IP address of the proxy
server, or the domain name. Example domain names
are: company.com and organisation.org.
Port number — The number of the proxy port. The
port number is related to the protocol. Common
values are 8000 and 8080, but vary with every proxy
server.
No proxy for — Define here the domains for which
the HTTP or HTTPS proxy is not needed.
to use
87