Ce Label; Operation; Starting Up The Product - Vaillant ecoCRAFT exclusive Operating Instructions Manual

4 Operation

Benchmark is managed and promoted
by the Heating and Hotwater Industry
Council. For more information visit
www.benchmark.org.uk.
▶
Please ensure that the installer has fully
completed the Benchmark Checklist on
the inside back pages of the installation
instructions supplied with the product
and that you have signed it to say that
you have received a full and clear ex-
planation of its operation. The installer
is legally required to complete a com-
missioning checklist as a means of
complying with the appropriate Build-
ing Regulations (England and Wales).
All installations must be notified to Local
Area Building Control either directly or
through a Competent Persons Scheme.
A Building Regulations Compliance Certi-
ficate will then be issued to the customer
who should, on receipt, write the Notifica-
tion Number on the Benchmark Checklist.
This product should be serviced regularly
to optimise its safety, efficiency and per-
formance. The service engineer should
complete the relevant Service Record on
the Benchmark Checklist after each ser-
vice.
The Benchmark Checklist will be required
in the event of any warranty.

3.5 CE label

The CE label shows that the products
comply with the basic requirements of the
applicable directives as stated on the iden-
tification plate.
The declaration of conformity can be
viewed at the manufacturer's site.
10
4 Operation

4.1 Starting up the product

4.1.1 Opening the isolator devices
1. Ask the competent person who in-
stalled the product to explain to you
where these isolator devices are loc-
ated and how to handle them.
2. Open the gas isolator cock fully.
3. Check that the heating installation flow
and return service valves are open, if
such service valves are installed.
4. If a domestic hot water cylinder is con-
nected, open the cold-water isolation
valve. To check, you can turn on a hot
water valve and see whether water is
escaping there.
4.1.2 Switching on the product
2
1. Use the main switch (1) to switch on
the product.
◁
1: "ON"
◁
When the main switch is in position
1, the product is switched on and
the standard display for the Digital
Information and Analysis System is
shown in the display (2). The func-
tion menu is immediately shown in
the display once the unit has been
switched on. The function menu en-
ables competent persons to control
how the individual actuators work.
The product returns to normal oper-
ating mode after a waiting period of
Operating instructions ecoCRAFT exclusive 0020149575_01
1