Table of Contents
Advertisement
1
Notes on the documentation
The following information is intended to help you through-
out the entire documentation. Further documents apply in
combination with these installation and maintenance
instructions.
We accept no liability for any damage caused by failure to
observe these instructions.
Other applicable documents
> When installing the ecoTEC plus, follow all installation
instructions for the various parts and components of the
system without exception.
These installation instructions are enclosed with the various
system parts and supplementary components.
> Furthermore, observe all operating instructions enclosed
with components of the system.
1.1
Storing documents
> Pass these installation instructions and all other applica-
ble documents and, if necessary, any required tools to
the system operator.
The system operator should retain these instructions and
tools so that they are available when required.
1.2
Symbols used
The symbols used in the text are explained below:
i
Symbol that denotes useful tips and infor-
mation
>
Symbol for a required action
1.3
Applicability of the instructions
These installation instructions are only valid for boilers with
the following article numbers:
Boiler
Type designation
ecoTEC plus 937 (VUI GB 376/5-5)
1.1 Unit types, article numbers and Gas Council Number
The article number of the boiler can be found on the identi-
fication plate.
Installation and maintenance instructions ecoTEC plus 0020134833_01
Gas
Article
Council
number
Number
0010011689
47-044-43
Notes on the documentation
1.4
Identification plate
The identification plate of the Vaillant ecoTEC plus is
attached to the underside of the boiler in the factory.
The article number of the gas-fired wall-hung boiler can be
found in the serial number. The seventh to sixteenth num-
bers constitute the article number.
The serial number can also be found on the lift out badge
located behind the front flap at the bottom of the boiler.
The serial number can also be shown on the display of the
boiler (Operating instructions).
1.5
CE label
The CE label shows that the boilers comply
with the basic requirements of the applicable
directives as stated on the identification plate.
– Directive 2009/142/EEC of the Commission with amend-
ments "Directive for Harmonisation of Legal Regulations
of the Member States for Gas Consumption Appliances"
(Gas equipment directive)
– Directive 92/42/EEC of the Commission with amend-
ments "Directive Concerning the Efficiency of New Hot
Water Heating Boilers Fired by Liquid or Gaseous Fuels"
(Efficiency directive)
– Directive 2006/95/EC of the Council with amendments
"Directive Concerning Electrical Equipment for Use
Within Specific Voltage Limits" (Low voltage directive)
– Directive 2004/108/EC of the Council with amendments
"Directive Concerning Electromagnetic Compatibility"
The boilers comply with the type sample described in the
EC Type testing certificate.
PIN no. CE-0085CM320
The boilers comply with the following standards:
– EN 483
– EN 625
– EN 677
– EN 55014
– EN 60335-1
– EN 60335-2-102
– EN 61000-3-2
– EN 61000-3-3
1
5
Advertisement
Table of Contents
