F.32 Risk of flue gas exit ..... 17 Care and maintenance ....17 Maintenance ........ 17 Caring for the product ....17 Decommissioning...... 17 Temporarily decommissioning the product........17 Permanently decommissioning the product........19 Recycling and disposal..... 19 Operating instructions ecoCRAFT exclusive 0020149575_01...
The product is intended as a Caution. heat generator for closed heat- Improper use of any kind is prohibited. 0020149575_01 ecoCRAFT exclusive Operating instructions...
▶ Do not use or store explosive bells, telephones or other or flammable materials (e.g. communication systems in petrol, paper, paint) in the in- the building. stallation room of the product. Operating instructions ecoCRAFT exclusive 0020149575_01...
Page 5
▶ Ensure that there is a suffi- caused by frost cient supply of combustion ▶ Ensure that the heating in- air. stallation always remains in operation during freezing con- ditions and that all rooms are sufficiently heated. 0020149575_01 ecoCRAFT exclusive Operating instructions...
Page 6
▶ Never attempt to carry out maintenance work or repairs on your product yourself. ▶ Faults and damage should be immediately rectified by a competent person. ▶ Adhere to the maintenance intervals specified. Operating instructions ecoCRAFT exclusive 0020149575_01...
– CE label ter cylinder Fault clearance The seventh to sixteenth digits of the serial number on the identification plate form the The display shows the current heating flow article number. temperature, the system pressure of the 0020149575_01 ecoCRAFT exclusive Operating instructions...
Page 8
If a control is connected, the rotary knob should be turned clockwise as far as it will go. The controller then determines the cylinder temperature. Operating instructions ecoCRAFT exclusive 0020149575_01...
– Symbol flash- ing: Burner anti-cycling time is active Vaillant is a licensed member of the Benchmark Scheme which aims to im- prove the standards of installation and commissioning of domestic heating and hot water systems in the UK and to en- courage regular servicing to optimise safety, efficiency and performance.
The declaration of conformity can be switched on. The function menu en- viewed at the manufacturer's site. ables competent persons to control how the individual actuators work. The product returns to normal oper- ating mode after a waiting period of Operating instructions ecoCRAFT exclusive 0020149575_01...
Page 11
4.1.4 Checking the system pressure ▶ Check the heating installation's filling pressure at regular intervals. Briefly press the − (1) button. 0020149575_01 ecoCRAFT exclusive Operating instructions...
Page 12
10. Top up with more water if necessary. cessary. Ask your competent 11. Close the filling tap and the heating person for details. water supply. Operating instructions ecoCRAFT exclusive 0020149575_01...
Page 13
2. Do not set the required cylinder tem- ature (1) in accordance with the outdoor perature at the rotary knob for the cyl- temperature. inder temperature; instead, set the 0020149575_01 ecoCRAFT exclusive Operating instructions...
The display shows the target cylin- ◁ The required temperature is shown der temperature of 15 °C for three in the display. After three seconds, seconds. this display goes out and the default display reappears (current heating flow temperature). Operating instructions ecoCRAFT exclusive 0020149575_01...
1. Switch on the chimney sweep function by pressing the − (2) and + (1) buttons for the DIA system at the same time. 0020149575_01 ecoCRAFT exclusive Operating instructions...
The condensate drain pipework and tun- ▶ If no control is present when dish must always be penetrable. a main switch has been switched on, set the rotary 0020149575_01 ecoCRAFT exclusive Operating instructions...
Page 18
Consult a competent person about this. in the scope of delivery for your product. They are installed on- site by the competent person. Ask the competent person to explain where the isolators are located and how they are oper- ated. Operating instructions ecoCRAFT exclusive 0020149575_01...
Alternatively - Just complete the Guaran- If the product contains batteries that tee Registration Card and return to Vaillant within 30 days of installation. Your details are marked with this symbol, these bat- teries may contain substances that are will then be automatically registered within the Vaillant scheme.
Condensate drain pipework blocked Check and, if required, clean the under or next to the condensate drain pipework product Leak in the system or the product Close the cold water supply to the product, inform a competent person Operating instructions ecoCRAFT exclusive 0020149575_01...
Need help?
Do you have a question about the ecoCRAFT exclusive and is the answer not in the manual?
Questions and answers