Packaged Components - Self-Lock Version; Powering Up And Battery Installation; Restoring Factory Codes; Care And Cleaning - COMPX Regulator AT Instruction Manual

Packaged Components cont.
Contents – Self-Lock Version:
•
•
•
•

Powering Up and Battery Installation

CompX
®
recommended. Mixing batteries of different chemistries could damage the
To power up
Note: In the event the batteries should die, they can be replaced via the external
battery compartment.
If equipped, a tamper resistant T-15 pin-in Torx
included) will be required to remove the battery cover.

Restoring Factory Codes

The RegulatoR -AT features a factory reset code which will restore the default
1-2-3-4 & 1-2-3-4-5 codes. The
one attached to the back of the
be kept in a safe and secure location for future reference if needed.
To restore the factory default codes, type the Factory Reset Code assigned to the

Care and Cleaning

To clean the
cotton cloth; do not spray cleaner directly on the
keypad and its respective housing surfaces of excess cleaner.
Self-locking
SlamCAM
(2) AAA alkaline batteries
SlamCAM spacer discs
Mounting hardware
is shipped with two installed AAA batteries. While
features a low battery indicator, scheduled battery replacement is
resulting in lock failure.
, pull the red tag. The lock is now ready for use.
and press and hold ENTER for 3 seconds.
surface, apply non-acid based cleaner to a clean
Lock assembly featuring
(6-lobe) bit or driver (not
®
was shipped with reset stickers;
and an extra sticker that should
, Keyless Locking 3
. Wipe down