Table of Contents
Advertisement
21.2 Factory Data Reset
This erases all data from the device's memory, and sets
it back to original factory settings. Make sure you have
backed up any important application-specific data to the
SD card. It does not erase data stored in the SD card,
unless the "Erase SD card" box is ticked.
H
1. Press
and tap Settings > Privacy > Factory data
reset.
2. Tap Reset device.
• The parent unit will power down automatically
during the reset.
3. The parent unit will automatically power up again and
launch Baby Monitor Setup Wizard to help you
configure the basic settings on your pa
"Baby Monitor Setup".
37
22. Help
How to get optimum connectivity and reception
between the parent unit and camera.
• If possible, position your wireless router in a central
location and closer to the parent unit and the camera.
The video screen hangs.
• Press
then select the camera again.
• Switch the camera on/off and connect again.
There is no response from the LCD touch panel
and parent unit keys.
• Press and hold
• Remove the parent unit battery and install again.
rent unit. See
The parent unit cannot find the camera unit.
• Check if the camera has been turned on and wait for
about 45 seconds.
• Check if the camera is ready for connection (LED is
blinking). If not, follow instructions on "Procedure for
resetting the Camera:"
I cannot create a new account in the server.
• Check if you have entered a valid email address for
the server to send you an email with the Activation
Key.
B
on the parent unit to exit the screen and
L
to turn off the parent unit.
Help
Advertisement
Table of Contents
