Table of Contents
Advertisement
EN 16
4.
Q528.2E LB
4.3
Assy/Panel Removal ME8(+) Styling
4.3.1
Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
Note: it is not necessary to remove the stand while removing
the rear cover.
Warning: Most sets have an additional hatch located in the
rear cover. These are meant for disconnecting the flat cables to
the AmbiLight units in the rear cover, before the rear cover is
lifted from the set. The hatches are not always located at the
same place for all sets, therefore the figures below are only
meant as indication.
2
2
2
2
2
2
Figure 4-15 Back Cover Removal [2/3]
Mechanical Instructions
2
2
2
Figure 4-14 Back Cover Removal [1/3]
3
H_17650_099.eps
180108
It is mandatory to locate these hatches first, open them, and
unplug connectors behind. Lifting the back cover without
having done so, could result in damaging the connectors
inside!
Refer to next figures for details.
1. First remove the screws [1] from the back cover hatch and
remove the hatch.
2. The unplug connector [3].
3. Remove the screws [2], gently lift the back cover from the
set and unplug the Ambilight power connector [4].
4. Lift the back cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
2
1
1
2
4
Figure 4-16 Back Cover Removal [3/3]
2
2
2
2 2
2
2 2
2
2
2
H_17650_100.eps
180108
H_17650_101.eps
180108
Hide quick links:
Advertisement
Table of Contents
