Table of Contents
Advertisement
USB-TEMP User's Guide
Documentation
In addition to this hardware user's guide, you should also receive the DAQ Software Quick Start
(available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf). Please read this
booklet completely before installing any software and hardware.
Unpacking the USB-TEMP
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the USB-TEMP from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If your USB-TEMP is damaged, notify Measurement Computing Corporation immediately by phone, fax,
or e-mail. For international customers, contact your local distributor where you purchased the USB-
TEMP.
!
Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
!
Fax: 508-946-9500 to the attention of Tech Support
!
Email:
techsupport@measurementcomputing.com
Installing the software
Refer to the DAQ Software Quick Start for instructions on installing the software on the Measurement
Computing Data Acquisition Software CD. This booklet is available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf.
Installing the hardware
To connect the USB-TEMP to your system, turn your computer on, and connect the USB cable to a USB
port on your computer or to an external USB hub that is connected to your computer. The USB cable
provides power and communication to the USB-TEMP.
When you connect the USB-TEMP for the first time, a
XP) or dialog (other Windows versions) opens as the USB-TEMP is detected.
When this balloon or dialog closes, the installation is complete. The
remain lit. This indicates that communication is established between the USB-TEMP and your computer.
Caution! Do not disconnect any device from the USB bus while the computer is communicating with
the USB-TEMP, or you may lose data and/or your ability to communicate with the USB-
TEMP.
Found New Hardware
USB LED
2-2
Installing the USB-TEMP
popup balloon (Windows
should flash and then
Advertisement
Table of Contents
Need help?
Do you have a question about the USB-TEMP and is the answer not in the manual?
Questions and answers