System Configuration - Lee Technology LTK-1100HN User Manual

● Remove the plastic bracket (included) under the Transmitter unit by unlocking
the 2latches.
● Place the plastic bracket against the wall and with the aid of a pencil, mark the
position of the mounting holes. (Refer to figure below). Mount the Transmitter in
a convenient location where a power outlet is available.
● Drill a hole on the marked position. Install the 3 mounting screws (and use
anchors where necessary). Ensure that the screws are not fully tightened so that
the unit can be easily removed from the wall.
● Place the Transmitter onto the wall (without the plastic bracket). Plug the 2-amp
wall Transformer into any suitable AC outlet. Plug the power connector into the
power jack on the top left hand side of the unit. Transmitter is now ready for use.
Be certain to mount the Transmitter away from phones, heat, moisture and
exposed power circuits. These items can damage your system and shorten
transmission range.

3) System Configuration

Your system was set at the factory and will function as soon as it is powered up.
Default setup is as follows
Current time is set.
Sleep shutdown on (battery operated pagers will be put to sleep at 1 am everyday)