Vertex Standard EVX-5300 Operating Manual page 13

prI-2 s
et
Press (or press and hold) the assigned PF key to toggle the current channel to the
priority channel 2 "enable" and "disable".
prI-2 d
IsaBle
Press (or press and hold) the assigned PF key to disable the priority channel 2 of
the group temporarily.
prI-2
Press (or press and hold) the assigned PF key to recall the pre-programmed PRI-2
(Priority-2) Channel directly. This is pre-programmed by your Vertex Standard
dealer.
d cH 1
Irect to
Press (or press and hold) the assigned PF key to recall the pre-programmed chan-
nel directly. This is pre-programmed by your Vertex Standard dealer.
s
can
The Scanning feature is used to monitor multiple channels programmed into the
transceiver. While scanning, the transceiver will check each channel for the pres-
ence of a signal, and will stop on a channel if a signal is present. EVX-5300 series
can scan both digital and analog frequency programmed channels simultaneously.
To activate scanning:
 Press (or press and hold) the assigned PF key to activate scanning.
 The scanner will search the channels of each channel, looking for active ones;
it will pause each time it finds a channel on which someone is speaking.
 Press (or press and hold) the assigned PF key again to disable scanning. Op-
eration will revert to the programmed revert channel.
Note: Your Vertex Standard dealer may have programmed your radio to stay on
one of the following channels if you press the PTT switch during the scanning
pause:
o "Scan Pause" channel ("Talk Back")
o "Last Busy" channel
o "Priority-2" channel
o "User Programmed" channel ("Select Channel")
o "Scan Start" channel
EVX-5300 O
pErating
a
dvanced
d cH 4
Irect
M
anual
o
peratIon
11