Page 2
Table of Contents Español ........................1. Antes de iniciar ....................2. Instalación del Hardware ................. Troubleshooting ...................... Version 11.01.2008...
“EXT” del AP exterior y enrosque la punta del conector de cable TEW-ASAL1. 2. Retire el guardapolvo del extremo del cable del TEW-ASAL1 y luego conéctelo al TEW-455APBO. 3. Retire el guardapolvo del otro extremo del TEW-ASAL1. 4. Conecte el extreme contrario del TEW- ASAL1 con una antena al aire libre.
Page 5
6. Envuelva la parte que rodea los conectores con las cintas impermeabilizadas suministradas. 7. Conecte el cable del conductor a tierra a un objeto de la toma a tierra. Ej. elemento conductor, sistema eléctrico de toma a tierra, estructura del edificio. Español...
Page 6
3. Afloje la tuerca y la arandela. Monte el TEW-ASAL1 en la abrazadera L. Luego apriete la tuerca y la arandela para fijar el TEW-ASAL1 a la abrazadera tipo L. Su configuración inalámbrica ha finalizado. Registre su producto Para asegurar los más altos niveles de servicio y apoyo al cliente, registre su producto www.trendnet.com/register...
Troubleshooting When I tried to screw in the TEW-ASAL1, it will not tighten. What should I do? First, make sure you are using a TEW-455APBO or an Outdoor Access Point with an N-type female connector. Make sure that your External Antenna also has an N-type female connector.
Page 8
TEW-ASAL1 3 Years Limited Warranty If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or part, deliver to customer an equivalent product or part to replace the defective item, or refund to customer the purchase price paid for the defective product.
Page 9
CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF TRENDnet'S PRODUCTS. TRENDnet SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY...
Page 10
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
Need help?
Do you have a question about the TEW-ASAL1 and is the answer not in the manual?
Questions and answers