Reset Factory Settings; Installation; Safety Information - Quuppa LD-6L Installation Manual

when Quuppa LD-6L is activated by the HAIP system.

Reset factory settings

To reset factory settings, press the reset button while connecting
power supply and keep it pressed for approximately three seconds
until the red indicator light stops flashing. After that the Quuppa LD-6L
switches on normally with the default factory settings.

3. Installation

Safety Information

Observe the following safety guidelines when installing Quuppa LD-6L.
• Only a qualified service technician should install or service
Quuppa LD-6L using the approved original Quuppa parts supplied
in the sales package. Faulty installation or service may be
dangerous and may invalidate any warranty which may apply to
Quuppa LD-6L.
• End users should remember that Quuppa LD-6L comprises of
complex
installation using special tools and expert know-how.
• Instructions given in this guide are general guidelines that apply
to the installation of Quuppa LD-6L in an indoor environment.
However, due to the wide variety of indoor environments and
mounting surfaces, this guide cannot consider the individual
technical requirements relevant for any particular installation.
Consult Quuppa in case you are uncertain about installation in a
specific indoor environment.
• Quuppa LD-6L is designed to operate either with a compatible
12V DC power supply, or by using a standard PoE (Power over
Ethernet) compatible network component connected at the
9 Quuppa LD-6L Installation Guide and Safety Information
technical equipment that requires professional
© 2013 Quuppa