Connect To Power Supply; Option 1: Use Power Over Ethernet (Poe); Option 2: Use Separate 12V Dc Power Supply; Connect To Haip Network - Quuppa LD-6L Installation Manual

Connect to power supply

Option 1: Use Power over Ethernet (PoE)

Quuppa LD-6L supports the use of standard PoE (Power over
Ethernet) components, e.g. PoE switch or power injector, as its
power source. Only use standard certified PoE devices.
When using PoE, a separate DC power supply is not required.

Option 2: Use separate 12V DC power supply

If you are not using PoE components, connect Quuppa LD-6L to
an approved DC power supply using the DC connector. Only use
compatible power supplies. Contact Quuppa in case of any
uncertainty regarding compatible power supplies.
When the power supply is connected Quuppa LD-6L automatically
switches on. The blue indicator light flashes once, after which the red
indicator light turns constantly on, until Quuppa LD-6L is connected to
the HAIP System.

Connect to HAIP network

Connect Quuppa LD-6L to the HAIP System with Ethernet CAT5 UTP
cable using the RJ-45 Ethernet socket. For your safety and to prevent
any damage to Quuppa LD-6L, only connect Quuppa LD-6L to standard
certified network components.
The red indicator light is flashing when Quuppa LD-6L is properly
connected to the HAIP System but not activated by the HAIP
Positioning Engine software.
Follow the Quuppa Deployment tutorial video to configure your
Quuppa LD-6L. The blue indicator light is flashing or constantly lit
8 Quuppa LD-6L Installation Guide and Safety Information © 2013 Quuppa