Rear Window Emergency Exit; Lift Arm Support Device - Gehl R190 Operator's Manual

Rear Window Emergency Exit

The ROPS/FOPS rear window has three functions: noise reduction, flying
objects barrier and emergency exit.
To use the emergency exit, pull on the yellow warning tag at the top of the
window and remove the seal. Push or kick out the window and then exit.
See your local automotive glass specialist to reinstall the window.

Lift Arm Support Device

The lift arm support device is used as a cylinder lock to prevent the raised lift arm
from lowering unexpectedly. Be sure to install the support device when the lift
arm is raised for service. When the support device is not being used, return it to
its storage position. The support device is a safety device, which must be kept in
proper operating condition at all times. The following steps ensure correct usage:
WARNING
person inside the loader and another person outside the loader to
engage the support device.
Important: With the key switch OFF and the solenoid valve working properly, the
lift arm will stay raised when the lift control is moved to lower the lift arm. If the
valve does not hold the lift am and it begins to lower do not leave the operator's
compartment. Instead, lower the lift arm and exit the machine. Then, contact
your Gehl dealer immediately to determine why the lift arm lowers while the key
switch is OFF.
Engagement
To engage the lift arm support device:
1. Lower the lift arm fully.
2. Stop the engine.
3. Have an assistant remove the lift arm
support device from its storage loca-
tion (Figure 4) on the left side of the
machine. Remove the lynch pin hold-
ing the support device up against the
lift arm. Allow the support device to
come down into contact with the lift
cylinder (Figure 3).
4. Restart the engine.
5. Use the lift control to raise the lift arm
until the support device drops over the
end of the lift cylinder and around the
cylinder rod. Slowly lower the lift arm until the free-end of the support device
contacts the top end of the lift cylinder.
22
The safest method of engaging the lift arm
support device requires two people - one
Figure 3 Lift Arm Support
Device Engaged
50950106/AP0313