Gira KNX/EIB Operating Instructions Manual page 12

KNX/EIB
InfoTerminal Touch
o Install the panel-mounted housing in the correct position - horizontally or vertically aligned
in the wall. Horizontal installation: Arrow OBEN TOP points upwards. Vertical installation:
Arrow OBEN TOP points to the left. Pull bus and 230 V lines through the designated
bushings.
o Pull the supplied tube over the stripped mains voltage wires.
o Connect mains voltage AC 230 V ~ to terminal (7).
o Connect bus line to terminal (8).
Use the Ethernet connection (15) together with the supplied Ethernet adapter plug and Ethernet
adapter cable to connect to the IP network.
Pay attention to the correct colour assignment of the wires, EIA/TIA-568-A or -B. This can be
found in the documentation of the installed network components and routers.
i The Ethernet connection on the device is carried out according to EIA/TIA-568-B.
o Connect Ethernet cable to the Ethernet adapter plug. To do this, strip the Ethernet wires,
do not skin, and insert into the cover of the adapter plug. Shorten any wires that are jutting
out and push the cover onto the adapter plug in the correct position.
o Connect the supplied Ethernet adapter cable to the terminal (15) and Ethernet adapter
plug.
o Install device in panel-mounted housing (18). Use the screws (16) supplied.
o Attach and press on the design frame (17).
32563342 10499271 I02
Figure 4
Figure 5: Installation in panel-mounted housing.
01.07.2011 12/14