Security Code Of Settings(Code) - Suntex EC-4110-I Operation Manual

7.2 Security code of settings
After entering set-up mode, select "code" item, press
procedure. The code pre-setting is 1111.
Note: The code of setting mode is prior to the code for calibration. That means that
the code of setting mode can be used for the code of calibration mode.
When a wrong password is
keyed in, the display shows
"Error Code", press to
re-key in it, or press to
exit.
(Select to turn on or turn off
code protection function. If
you select turn on, please
key in a new code. There
will be a code requirement
showing in display when you
re-enter to the setup mode.
Key in the correct password
to enter into setup mode.)
Press
Press
Press or
Press
Enter "Language" Setup
to enter into code
to confirm it.
The first '0" of digits '0000" start
to twinkle. Press
adjust the value, and then press
to confirm it and continually key
in the next digit, and so on.
to confirm it.
Key in new password
to confirm it.
or to
Press to confirm it.