Specifications; General Specifications - TP-Link TL-SG108PE Installation Manual

Specifications

General Specifications

IEEE802.3, IEEE802.3i, IEEE802.3u, IEEE802.3ab,
Standard
IEEE802.3af, IEEE802.3x, IEEE802.1p, IEEE802.1q
8 10/100/1000Mbps RJ45 Ports
Interface
Auto-Negotiation, Auto MDI/MDIX
PoE Ports: Port1- Port4, Total Power Supply: 55W
Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)
Data Transfer Rate
Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex)
Gigabit Ethernet: 2000Mbps (Full Duplex)
10Base-T:
UTP category 3, 4, 5 cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
100Base-TX:
Network Media (Cable)
UTP category 5, 5e cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
1000Base-T:
UTP category 5e cable or above (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
External Power Adapter
Power Supply
Input: 100-240VAC, 50/60Hz, Output: 48VDC /1.25A
Switching Capacity
16Gbps
MAC Address Table
4K, automatically learning, automatically aging
Wall Mountable Yes
Distance Between
110mm
Mounting Holes
Environmental and Physical Specifications
Certification
FCC, CE, RoHS
Operating Temperature
0˚C to 40˚C (32˚F to 104˚F)
Storage Temperature
-40˚C to 70˚C (-40˚F to 158˚F)
Operating Humidity
10% to 90%RH non-condensing
Storage Humidity
5% to 95%RH non-condensing
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
TP-Link hereby declares that the device is in compliance with the essential requirements and other
relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other
relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Safety Information
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
• Adapter shall be installed near the equipment and shall be easily accessible.
Frequently Asked Questions (FAQ)
Q1. Why is the Power LED not lit?
The Power LED should be lit when the power system is working normally. If the
Power LED is not lit, please try the following:
A1: Make sure the power adapter is connected to the switch with power source
properly.
A2: Make sure the voltage of the power supply meets the requirements of the
input voltage of the switch.
A3: Make sure the power source is ON.
Q2. Why is the Link/Act LED not lit while a device is connected
to the corresponding port?
Please try the following:
A1: Make sure that the cable connectors are firmly plugged into the switch and
the device.
A2: Make sure the connected device is turned on and works normally.
A3: The cable must be less than 100 meters long (328 feet).
Q3. Why is port 4 not supplying power for PoE devices?
If connected PoE devices' total power consumption exceeds 55W, the system
will cut off the power of port 4. For example, port 1, 2 and 4 are consuming 15.4W
respectively, if an additional PoE device with 12W is inserted to port 3, the system
will cut off the power of port 4 to compensate for the overload.
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
• Use only power supplies which are provided by manufacturer and in the origin
packing of this product. If you have any questions, please don't hesitate to contact us.
BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。
限用物質含有情況標示聲明書
限用物質及其化學符號
產品元件名稱
鉛 鎘
Pb Cd
PCB
外殼
電源適配器
備考1. "超出0.1 wt%"及"超出0.01 wt%"系指限用物質之百分比含量超出百分比含
量基準值。
備考2. " "系指該項限用物質之百分比含量未超出百分比含量基準值。
備考3. " "系指該項限用物質為排除項目。
Explanation of the symbols on the product label
DC voltage
Indoor use only
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU
in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment.
汞 六價鉻 多溴聯苯 多溴二苯醚
Hg CrVI PBB PBDE